Back to Blog
Tips & Care 2026-11-13 THESE ARE THINGS® – Enamel Pins • Iron On Patches 10 views

Boss Witch Patch: Iron-On Placement and Care Tips

Boss Witch Patch: Iron-On Placement and Care Tips

Learn how to iron on the Boss Witch Patch, choose a spot on a denim jacket, and care for the embroidered design so it stays put. Practical tips inside.

Start with the right spot on your denim jacket

The Boss Witch Patch measures 2.5" wide, so it fits comfortably on a jacket back, chest, or sleeve without overwhelming the garment. Before you iron, try the patch in a few spots and check that the phrase "I put a spell on you" reads clearly and isn't distorted by a seam or pocket flap. Avoid placing it over thick seams, zippers, or areas that flex constantly, as these can make adhesion less reliable.

Denim is a dense fabric that holds creases, so smooth the area flat and consider pressing it with an iron first to remove wrinkles. A flat, stable surface gives the adhesive the best chance to bond evenly.

How to iron on the Boss Witch Patch

These steps follow common iron-on practice for embroidered patches. The catalog confirms an iron-on adhesive backing but does not list specific temperature or time settings, so adjust based on your iron and fabric.

  1. Preheat your iron: Set your iron to a medium heat suitable for denim. Turn off steam, as moisture can interfere with the adhesive.
  2. Position the patch: Place the Boss Witch Patch adhesive-side down on the chosen spot. Pin or hold it in place if needed.
  3. Cover and press: Lay a thin cotton cloth or pressing cloth over the patch. Press the iron firmly on the cloth for several seconds, moving slowly to cover the whole patch.
  4. Check the bond: Let the patch cool slightly, then gently lift an edge. If it lifts, repeat the pressing step.
  5. Reinforce if desired: For extra security on high-wear areas, sew a few stitches around the border after ironing.

What the catalog confirms about the Boss Witch Patch

  • Boss Witch Patch: Embroidered patch design with iron-on adhesive backing. The embroidery gives a textured look, and the adhesive backing means you can apply it with heat rather than sewing.
    Boss Witch Patch
    Boss Witch Patch
  • Boss Witch Patch: Measures 2.5" wide. This size is versatile for jacket fronts, backs, or bags, and helps you plan placement without overwhelming the garment.
  • Boss Witch Patch: Text reads: "I put a spell on you". The phrase is the focal point, so position the patch where it will be readable and not folded or covered.

Keep the patch from peeling

Iron-on patches can lift over time, especially on areas that stretch or rub. To reduce peeling, avoid ironing over seams, and make sure the fabric underneath is clean and dry before applying. After ironing, let the patch cool completely before wearing the jacket. If you notice an edge starting to lift, re-press it with a cloth and iron, or add a few stitches for reinforcement.

Washing inside out in cold water and air-drying will also help preserve the adhesive and the embroidery.

Caring for your witch patch

The Boss Witch Patch is embroidered, so treat it gently to avoid snags. When washing the jacket, turn it inside out and use a gentle cycle with cold water. Avoid bleach and fabric softeners, which can degrade the adhesive and threads. Air-drying is safest; if you must use a dryer, use low heat and remove the jacket promptly.

If the patch needs cleaning, spot-clean with a damp cloth and mild soap, then air-dry. Do not scrub the embroidery, as this can loosen threads.

Related Articles

Customer Service
Home
Products
Cart
Profile